Banks Power Interface- Banks iQ 1996 & Later Vehicles with OBDII Diagnostics - Manual (Page 42)

42
97272 v.1.0
Alert indicator Description
SEARCHING- A searching icon will
indicate a communication error between
the Banks iQ, Bridge, Tuner, Brake, and/
or the vehicle. Go over all wiring and
make sure they are proper connected.
VEHICLE SPEED- The vehicle speed
icon will indicate the vehicle speed is
above the user alert set point. Lower
your speed below the set speed to
clear the alert.
OIL TEMP- The vehicle engine oil
temperature is over the user set alert
point. Safely stop the vehicle and
check the engine oil.
RPM- The vehicle RPM is over the user
set alert point. Reduce speed to lower
RPM. If alert continues, safely stop the
vehicle and check your engine.
ENG TEMP- The enigne temperature
is over the user set alert point. Safely
stop the vehicle and check the engine.
Go to the begin of this section to
adjust the user alert set point for any
alert.
-END, SECTION 20-
Max Values allow you to observe
the maximum values that have been
achieved for the parameters available
for your vehicle since the last Reset
cycle. See Figure 39.
1.
To view Max Values, in the
‘Adjustments’ menu press the Max
value button.
2.
After viewing your Max Values you
can reset to clear the current values.
Press the ‘Reset’ button in the lower
right hand corner. A pop-up screen will
appear to confirm reset. Press ‘yes’
to confirm reset value, press ‘no’ to
cancel reset.
3.
After viewing your Max Values,
press the ‘Banks iQ’ icon to return
to the current mode screen or
the ‘Return’ icon to return to the
‘Adjustments’ menu.
-END, SECTION 21-
Section 21
MAX VALUES
Figure 39