Banks Power Interface- Banks iQ 1996 & Later Vehicles with OBDII Diagnostics - Manual (Page 41)

97272 v.1.0
41
Figure 38 Alert indicator icons
1.
Select the ‘Wrench’ icon to go to
the ‘Adjustments’ menu. Press the
‘On Screen Alerts’ button.
2.
Scroll Up or Down through the
optional Alert Parameters available on
the left hand side of the screen. See
Figure 37.
3.
Highlight the desired parameter on
the left side of the screen.
4.
Press the plus (+) or minus (-)
symbols to increase or decrease the
selected parameter Alert Set Point.
The display shows the adjusted value.
NOTE: The limit for each parameter
Alert Set Point is displayed right above
the adjusted value Set Point.
5.
To set the volume sound level for
the alerts, Press the plus (+) or minus
(-) symbol below the ‘Reset’ button to
increase or decrease the sound level.
Three (3) volume levels plus a silent
mode are available.
6.
Repeat steps 2 through 5 to adjust
all the desired parameters.
7.
Once all parameter have been
adjusted and to save changes, press the
iQ icon to return to the current mode
screen or the ‘Return’ icon to return to
the ‘Adjustments’ Menu.
NOTE: In the event an alert set point
is reached an audible alarm will sound
and the Status Indicator will display
an icon relative to the associated
alert. See Figure 38 and the alert
descriptions. The alarm will turn off
once the associated parameter is
below its alert set-point. The Status
Indicator will then return to ‘OK’.
8.
You can return Banks iQ to its
default alert settings at any time by
pressing the ‘Reset To Default’ button.
Section 20
On SCREEn ALERTS
Figure 37 Alert Screen