TC Electronic Studio Konnekt 48 - Manual (Page 11)

DAW
In this section you route the outputs of your DAW.
DSP
The DSP outputs are: Main, AUX1, AUX 2 outputs and
Fabrik R sends. The AUX outputs are typically used for
headphones.
S Sp pe ea ak ke err S Se ettss
Three speaker setups can be setup and switching between
the sets is easy. The speaker setups A, B and C can be
individually labeled according to your specific application.
8 Speaker or Line level ?
In the speaker section you select whether the signal is
routed to a speaker or directly to a line output at max
level. If this box is checked the level can be controlled
by the master level of the remote control. If not, line
is sent to outputs regardless of the master level
setting.
IIM MP PO OR RT TA AN NT T !!
If a source signal is NOT assigned to a speaker set,
you can check “DIRECT” and thus route the signal
directly to the mains out at F
FU UL LL L V VO OL LU UM ME E..
If you e.g. have active monitors connected to the
outputs and these set at full volume, then sending
a signal, also at full volume, may damage the
speakers.
A pop-up dialog box will ask you to reconsider
before sending the un-attennuated signal to outputs.
9 Assigned to
Indicates which speaker set or sets the source is
assigned to.
19
Routing Channels to Outputs
Introduction - basics
The main purpose of the output section is routing of the
physical, DAW and FireWire input channels to the
physical outputs. Starting from left going to right we have
the:
- the Source select that allows you to select the input
you intend to route
- the option of routing source signal to any of the three
speaker sets A, B, C and furthermore setting individual
trim and delay for each source
- giving the outputs personal labels
.....let us take a look at each element of the Output
section in detail.
6 Link button
This button allows you to link/unlink channel pairs.
Example: Typically, you would prefer having main outputs
linked, but you may unlink main L and main R if
individual delay or trim is needed.
Linked
Unlinked
7 Source select
Via the source select drop down menu you select the
signal you are about to route. The options are:
Physical:
These are the physical inputs on Studio Konnekt 48.
18
SETUP PAGE SETUP PAGE