TC Electronic Studio Konnekt 48 - Manual (Page 34)

65 64
3 Mode selector
Click to switch between Strobe and normal mode.
Strobe mode: Sections of three red LEDs will slide left, when the played note is too low, and right when it is too high.
...out of tune (Chromatic scale-mode selected) ...in tune (C major scale-mode selected)
4 Play tone
Press PLAY TONE if you want to tune acoustically to a reference tone. The played note is “A” according to the set pitch
(default 440Hz).
The level of the tone can be adjusted using the small “speaker” handle located just below the PLAY TONE button.
5 Pitch
Sets the reference frequency. Default value is 440Hz and the range is from 438 to 445.
6 Mute
Press to mute the output of the tuner. Excellent if you need to tune visually only.
7 Scale modes
The following scale modes are available via the drop down menu:
TUNER TUNER
Studio Konnekt 48 holds an excellent tuner with various modes for stringed instruments. The Tuner page holds all relevant
parameters as well as the tuner display. It is also possible to have Tuner indication via the lightring on the Konnekt unit.
This is excellent for stand-alone applications.
The Tuner page
Let us take a look at the Tuner page in the TC Near Control panel.
1 Tuner Indication.
In strobe mode: Three LEDs are always lit. If the played note is too low the LEDs run from right to left. Opposite if the
pitch is too high.
In normal mode: Three green LEDs in center position indicates that the played note is in pitch.
2 Note indication
The displayed notes reflect the selected scale mode. In the example above all 8 pitch notes are indicated because the
C-Major scale mode is selected (see also #8).