TC Electronic Studio Konnekt 48 - Manual (Page 20)

default to “Master” after TALK has been used.
Instead the TALK button has a latching and a
momentary function.
Latching: Press TALK once to activate “talk”. Press
once more to deactivate “talk”.
Momentary: Press and hold to speak. Release to
return to normal.
TUNER (SHIFT + TALK)
The lightring around the encoder can also be used as
a convenient tuner if you e.g. have a guitar or a bass
plugged into one of the channel preamps on the front
of Studio Konnekt 48. The tuner on the Studio
Kontrol remote has a strobe and a point mode just as
the tuner on the Tuner page. The selected mode
follows the mode selected on the TC Near tuner page.
Default mode is: Point mode.
15 MASTER
This is the default setting for the remote that assigns
the encoder to control the master volume.
9 ENCODER and LIGHTRING
The encoder is used to change values for the selected
parameter or function. The encoder and lightring have
various secondary functions when pressed once.
Dim function:
Master, aux 1 , aux 2 and Main mix can have can have an
individual dimmed level setting. Press the encoder to go
to dimmed mode and once more to exit. Dim mode is also
indicated on the lightring. See illustration below.
Not dimmed Dimmed
The dimmed level cannot be set higher that the
normal level.
10 PANEL
Once you have the TC Near control panel opened, the
PANEL button is a convenient way to maximize the
control panel on top of your DAW application - and
minimize it again. No need to use mouse or keyboard.
11 SPEAKER SET select
• Press and hold:
while pressing: or or
to select speaker sets.
NEL
(P1-P3)
MIC PROG
P2 P3
NEL
(P1-P3
MIC PROG
P2 P3
16 CH on/off - (Channel on/off)
With the CH on/off activated (LED is lit) the 6 buttons
in the top of the remote can be used to mute/un-mute
channels. As explained previously, these buttons have
six primary assignments: MIC1, MIC2, S/PDIF, CH
5/6, CH 7/8 and DAW.
The Channel on/off function will also work on
channels assigned to the 6 USER assignments.
Enable shift and press one of the top 6 buttons.
17 SHIFT
Press to allow secondary functions. Some functions
require that you press SHIFT once. Some functions
require that you press and hold SHIFT. Please refer to
the descriptions on this and the previous pages.
12 M. MIX - (MON MIX)
The level control for the mixer outputs.
AUX 1 - (SHIFT + M. MIX)
Level control for the AUX 1 channel.
13 EFFECT
Controls the Fabrik R Studio return level on the Main
Mix channel.
AUX 2 - (SHIFT + EFFECT)
Level control for the AUX 2 channel.
14 TALK
When activating the talkback function you most likely
want to attenuate the mix level in the performer’s
headphones. The Dim Level function sets this level.
The dim level can never be set higher than the normal
level.
The AUX sends are typically used for setting
individual mix levels on the two headphones outputs.
The AUX 1, AUX 2 and MAIN buttons determine to
which outputs the talkback signal should be sent.
Press the TALK switch on the Studio Kontrol or on the
mixer.
Momentary or latching
Unlike all other functions the Studio Kontrol will not
STUDIO KONTROL STUDIO CONTROL
37 36