TC Electronic Studio Konnekt 48 - Manual (Page 30)

57 56
Additional parameters
Bypass
Bypass function for the entire plug-in.
In/Out
In level Range
: -24 to 0 dB
Out level Range : -24 to +12 dB
Sets the Input/Output levels for the algorithm. If the
Internal overload indicators “O/L” are lit, you may need to
readjust the In/Out levels.
Meters
In and output meters. For best performance the In meter
should show as close to 0 dB as possible without
clipping.
Kill Dry - Kill wet
A reverb can be used either as an insert effect or as a
send effect.
Most often it is used as a send effect on a bus. The bus
is fed from the channels you apply the effect to. When
used as a send effect the Kill Dry should be set to “on”
and this is also the default setting. When used as an
insert channel, dry signal is necessary and Kill Dry should
be set to “off”.
FABRIK R STUDIO FABRIK R STUDIO
The Color parameter controls are advanced controls
handling the sonic spectrum of the Reverb diffuse field.
Try adding a bit of HiColor if you feel the level of reverb is
correct, but still doesn’t stand out as intended.
LoColor
Low Color adjustment of the Decay.
HiFactor
The HiFactor parameter is used to enhance or attenuate
the frequency area set by the HiColor parameter.
HiColor
HiColor adjustment of the Decay. This parameter selects
frequency area in focus.
Color page Level page
The relation between Dry, Early and Reverb levels defines
the perceived distance of a source. The less dry the signal
compared to Early and Reverb levels, the greater the
perceived distance. Early and Reverb levels set the
relation between the amount of room definition compared
to the reverb diffuse field.
If the Kill Dry button is pushed, Dry Level is fixed at off.
If the Kill Wet button is pushed, Early and Reverb Levels
are fixed at off.
Dry
Range: Off, -24 dB to 0 dB
Sets the amount of dry level passing through the algorithm.
Early
Range: Off, -24 dB to 0 dB
The Early Reflections are the defining basis of the Reverb
diffuse field. Adjust the amount to set the emphasis
between the Early Reflections and the Reverb diffuse field.
Reverb
Range: Off, -24 dB to 0 dB
The Reverb parameter sets the amount of applied
reflections from the Reverb diffuse field.
Routing modes
Two routing modes can be selected via the Routing mode
drop-down menu.
Plug-In mode - must be selected when Fabrik R Studio is
used as VST plug-in.
Internal mode - Use internal mode when Fabrik R is used
without a host program with VST facilities.
Example:
Using Plug-In mode in a recording situation will add a
slight delay on the reverb. The delay length is depending
on the selected Buffer Size (set on the System Settings
page). However, as the reverb is used as a send effect,
unlike Fabrik C which processes the entire signal, you will
most likely not notice that delay in a recording situation
on the Reverb. Therefore we suggest using the Plug-In
mode for Fabrik R in both recording and mixing.