TC Electronic Studio Konnekt 48 - Manual (Page 29)

55 54
FABRIK R STUDIO FABRIK R STUDIO
Tweak section
In this section, all parameter adjustments are made.
Parameters are organized in 4 different layers/pages.
Level
Color
Modulation
Time
There are a couple of different ways of altering the
parameter values:
• Grab and move the icon (e.g. TIME) in any direction.
This way of changing parameter values gives an excel-
lent intuitive feeling.
• You can of course also change parameter values by
grabbing the parameter value fields and move the
mouse up or down.
• Finally, values can be entered numerically by double-
clicking on the parameters value fields and entering
values using the keypad.
0 dBFS
- 0.5
-1
-2
-3
-4
-5
-6
-8
-10
-12
-14 -16
-18
-20
-22
-24
-30
-36
-42
-48
-56
-64
-72
Meters
The list below shows the exact distribution of value
readings on the meter segments on both IN and OUT
meters. A precise reading close to 0dBFS and around key
values such as -18, -20 and -24 dBFS is imperative and
this distribution takes these key values into consideration.
O/L - Overload indication
Internal overload is indicated via the O/L indicators
located between the In/Out meters. Internal overload may
occur at certain extreme parameter settings even when
the In Level meters show reasonable levels.
Use the In/Out parameters to compensate.
Time page
Decay
Range: 10 ms to 20 sec
The Decay parameter determines the length of the Reverb
Diffuse Field. The length is defined as the time it takes
for the Diffuse Field to decay approximately 60dB.
PreDelay
Range: 0 to 100 ms
A short Delay placed between the direct signal and the
Reverb processing. A Pre Delay is often used to keep the
source material clear and undisturbed by the Reverb
Diffuse Field.
Modulation page
The algorithm designers have adjusted the diffuse field
part of the reverb to be as smooth and natural sounding
as possible. However, by modulating the diffuse field, the
reverb will, in certain cases, integrate better with the
entire signal. You may also find the modulation
parameters useful simply to create new flavors of reverb.
Modulation Rate
Range: +/-25
Adjusts the Rate of modulation.
Modulation Depth
Range: 0 - 200%
Adjusts the Depth of modulation.