TC Electronic Studio Konnekt 48 - Manual (Page 21)

EFFECT button
Via the drop-down menu the EFFECT button can be set in
two modes. Reverb Time/Decay or MIDI
REVERB TIME/DECAY
When the REVERB TIME/DECAY option is selected you
can control each of these parameters by turning the big
encoder. To alternate between Reverb Time and Reverb
Decay level simply click once on the encoder.
MIDI
The big encoder can also be used to send MIDI
information. The MIDI information is either sent to the
Studio Konnekts MIDI out port and/or to the DAW.
- Select MIDI in the EFFECT buttons drop-down menu.
- Then set MIDI channel and MIDI controller type from
the drop down menus in normal mode and push
mode.
STUDIO CONTROL REMOTE PAGE
39
The Remote page handles various options for the Studio
Kontrol.
F Fa allllb ba acck k tto o m ma asstte err
The big encoder is per default assigned to control the
master volume. However, it can also be used to adjust the
other parameters that can be selected via the Studio
Kontrol buttons. Via the The Fallback to master drop-
down menu you can set the time it takes before the
encoder controls the master volume again after it has
been assigned to another parameter.
Example:
-
Notice that the LED in the MASTER button is lit,
indicating that the big encoder controls the MASTER
level parameter.
- Set Fallback time to 2.5 seconds.
- Press MIC1 and turn the big encoder. You are now
adjusting the level of the MIC1 channel.
- Don’t touch the encoder for 2.5 seconds and see that
the MASTER button is lit again indicating that the
encoder now controls the master level again.
L LE EV VE EL L k kn no ob b -- M Miixx p pu ussh h m mo od de e
The big encoder on the Studio Kontrol can also be used
to adjust the following parameters; Pan/Balance, Reverb
Send and AUX 1/2 send levels.
- Select the parameter from the drop-down menu
- Then press e.g. the MIC1 button for the front panel
channel 1
- Now click once on the big volume knob and turn to
adjust the parameter value
After the interval set by the “Fallback to Master“
parameter, the encoder returns to the state where it
controls the master level.
STUDIO CONTROL REMOTE PAGE
38