TC Electronic Studio Konnekt 48 - Manual (Page 14)

F Fe ea attu urre ess iin n tth hiiss sse ettu up p
• One stereo set of active speakers and one active Sub.
The sub is fed with both the LFE channel signal and
lo-freq signal from the main channels via bass
management.
• Two separate sends for monitoring on headphones via
AUX 1 and AUX 2 sends on the TC Near mixer page
• Computer with TC Near control panel and DAW
application
• Integrated external digital reverb via S/PDIF and the
Integrator plug-in*
• Integrated external analog filter via analog line I/O
* Please refer to the instructions for the Integrator plug
in on the following pages.
S Se ettttiin ng g u up p
• Select DAW Main Out 1+2 as source. Set
speaker to “on” and assign to main.
• Select DAW Line Out 8 as source and
assign this channel as “SUB”.
• We have set a typical X-over frequency
of 95 Hz. Low-pass is set to 24 dB/oct
and High-pass to off.
SETUP EXAMPLES - BASS MANAGEMENT & INTEGRATION SETUP EXAMPLES - BASS MANAGEMENT & INTEGRATION
25 24
REVERB 4000
ANALOG FILTER
ACTIVE SPEAKERS
MAIN
L
MAIN
R
SPDIF
LINE
5
OUT
FIREWIRE
M.MIX PANEL
MIC1 CH5/6 USER 4 USER 5 USER 6
AUX1 A B C
USER 1 USER 2 USER 3
AUX2
(P1-P3)
TUNER
studiokontrol
MIC
EFFECT
MIC2 CH7/8
TALK
SPDIF DAW
MASTER CH on/off
PROG
SHIFT
P1 P2 P3
STUDIO CONTROL
CAT 5
studiokonnekt 48 output max min mic/inst input mic/inst input mic/inst input mic/inst input
-20dB -20dB -20dB -20dB OFF OFF OFF OFF PAD PAD PAD PAD
IMPACT II IMPACT II IMPACT II IMPACT II technology technology technology technology TM TM TM TM
channel 1 preamp channel 2 preamp channel 3 preamp channel 4 preamp phones 1 phones 2
gain trim gain trim gain trim gain trim max max max max min min min min (ch3-4) (ch11-12)
power 48V
ON OFF
master level valid 1-8 IN 1-2 OUT 1-2 3-4 ADAT SPDIF TOS MIDI FireWire
1 2 3 4 5/6 7/8 9/10 11/12
-3 O
-6 -12 -24 -40 dB
DAW COMPUTER
WITH FIREWIRE
IN
SUB
LEFT RIGHT
LINE
8
OUT
LINE
5
IN