Apple Nike + iPod Sensor - Manual (Page 138)

138
This product was tested for EMC compliance under conditions that
included the use of Apple peripheral devices and Apple shielded cables
and connectors between system components. It is important that
you use Apple peripheral devices and shielded cables and connectors
between system components to reduce the possibility of causing
interference to radios, television sets, and other electronic devices. You
can obtain Apple peripheral devices and the proper shielded cables
and connectors through an Apple Authorized Reseller. For non-Apple
peripheral devices, contact the manufacturer or reseller for assistance.
Responsible party (contact for FCC matters only):
Apple Inc. Corporate Compliance
1 Infinite Loop, MS 26-A
Cupertino, CA 95014
Wireless Information
FCC Wireless Compliance for the Nike + iPod Sensor. The antenna used
with this transmitter must not be colocated or operated in conjunction
with any other antenna or transmitter subject to the conditions of the
FCC Grant.
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of the device.
Cet appareil est conforme aux normes CNR exemptes de licence
d’Industrie Canada. Le fonctionnement est soumis aux deux conditions
suivantes : (1) cet appareil ne doit pas provoquer d’interférences et (2) cet
appareil doit accepter toute interférence, y compris celles susceptibles de
provoquer un fonctionnement non souhaité de l’appareil.
Industry Canada Statement
Complies with the Canadian ICES-003 Class B, RSS 200 specifications. Cet
appareil numérique de la classe B est conforme
à la norme NMB-003 RSS 210 du Canada.
European Wireless EU Declaration of Conformity
This wireless device complies with the specifications EN 300 328, EN
301-489, EN 50371, and EN 60950 following the provisions of the R&TTE
Directive.