Sena Bluetooth SPH10S v4.1 User's Guide - Manual (Page 13)

SPH10S
12
Voice Prompt “VOX phone”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
VOX phone
PLC setting
Exit configuration VOX intercom
Delete all pairings Voice prompt
The voice prompt for each menu item is as below:
(1) VOX phone (4) PLC setting
(2) VOX intercom (5) Delete all pairings
(3) Voice prompt (6) Exit configuration
9.1 Enabling/Disabling Voice Activated Phone
Answering
If this feature is enabled, you can answer incoming calls
by simply saying a word loudly enough. For example,
when you hear a series of beeps for an incoming call,
you can answer the phone by saying “Hello” or any
other word loudly. This is enabled from the factory but
you can disable this. If this mode is disabled, you have
to tap the Jog Dial or the Phone Button to answer an
incoming call.
9.2 Enabling/Disabling Voice Activated
Intercom
If this feature is enabled, you can initiate an intercom
conversation with the last connected intercom friend
by speaking any word loudly enough. The most
effortless way to trigger intercom VOX is to blow into
the microphone as if blowing dust off the microphone.
If you start an intercom conversation by VOX, the
intercom terminates automatically when you and your
intercom friend remain silent for 20 seconds. However,
if you manually start an intercom conversation by
tapping the Jog Dial, you have to terminate the intercom
conversation manually.
Voice Prompt “VOX intercom”
Factory Default Disable
Enable Tap the Phone Button
Disable Tap the Jog Dial