SENA UPSLink100 - Manual (Page 13)

13
2.3 Accessing the UPSLink
There are several ways to access the UPSLink. These methods are dependent on whether the user is
located at a local site or a remote site, or whether s/he requires a menu-driven interface or graphic
menu system.
System console:
Local users can connect directly to the system console port of the UPSLink using the serial console
cable and the terminal emulator like HyperTerminal in Windows.
Telnet:
Remote users who require a menu-driven interface can utilize Telnet (port 23) connections to the
UPSLink using a Telnet program.
Web:
Remote users who want to use a web browser to configure the UPSLink can access the UPSLink
using conventional web browsers, such as Internet Explorer or Netscape Navigator.
The UPSLink requires user authentication for all the above methods.
2.3.1 Using system console
1) Switch Data/Console mode selector of the UPSLink to Console mode.
2) Connect one end of the console cable to the console port on the UPSLink.
3) Connect the other end of the console cable to the serial port of a user’s computer.
4) Run a terminal emulator program (i.e. HyperTerminal). Set up the serial configuration
parameters of the terminal emulation program as follows:
 9600 Baud rate
 Data bits 8
 Parity None
 Stop bits 1
 No flow control
5) Press the [ENTER] key.
6) Enter your user name and password to log into the UPSLink. The factory default user
settings are as follows.
Login: admin Password: admin