SENA UPSLink100 - Manual (Page 42)

42
7.5 Factory default reset
A user may restore the factory default settings at any time by selecting “Factory reset” or by pushing
the factory default reset switch on the top side panel of the UPSLink. If a user must reset all settings
except the IP Address, s/he may select “Factory reset except IP settings”. Figure 0-8 shows the
factory default reset screen.
Figure 0-8 Factory default reset
7.6 Firmware upgrade
Firmware upgrades are available via serial, remote console or web interface. The latest upgrades are
available on the Sena web site at http://www.sena.com/support/downloads/.
Figure 0-9 shows the firmware upgrade web interface.
To upgrade firmware via the web:
1. Download the latest firmware from the Sena web site.
2. Click on the browse button and select the firmware.
3. Click on the upload button.
4. Once the upgrade has been completed, the system will reboot to apply the changes.
Warning : Do not turn off the power while downloading the firmware. This will cause serious system
damage.
Figure 0-9 Firmware upgrade