8 ethernet configuration – SENA UPSLink100 User Manual
Page 34
Advertising
34
information about the configuration of the UPS alarm and system log storage location, please refer to
section 0. 3.7 UPS alarm log and 0. 6.2 System log configuration.
4.8 Ethernet configuration
The UPSLink supports several types of Ethernet modes:
- Auto Negotiation
- 100 BaseT Half Duplex
- 100 BaseT Full Duplex
- 10 BaseT Half Duplex
- 10 BaseT Full Duplex
After changing the Ethernet mode, the user must reboot the system. The factory default value of the
Ethernet mode is Auto Negotiation. With most network environments, Auto Negotiation mode should
work fine and recommended. Invalid Ethernet mode settings will not make the UPSLink work in the
network environment.
Figure 0-8 Ethernet mode configuration
Advertising