SENA Parani-SD1000U - Manual (Page 34)

CURRENT MODE: MULTI-DROP MODE
TASK1
– 000195000001
TASK2 – DISCONNECT
TASK3 – DISCONNECT
TASK4 – 000195000004
A.3.11. AT+BTMODE,n
Response  OK
Purpose Set operation mode
Parameters n=0: MODE0 (Default)
n=1: MODE1
n=2: MODE2
n=3: MODE3
Description When the operation status is „Pending‟ currently, change the status to „Standby‟ with
AT+BTCANCEL prior to this command.
To take effect the ATZ must be executed or the unit is connect to usb port
Example AT+BTMODE,2
 OK
ATZ
A.3.12. AT+MULTI,n
Response  OK
Purpose Set multiple connection mode
Parameters n=0: Single Connection Mode (Default)
n=1: Multi-Drop Mode
n=2: Node Switching Mode
Description Set single connection mode, multi-drop mode or node switching mode.
A.3.13. +++
Response  OK
Purpose Convert the operation status of „Connect‟ to „Standby‟
Description In „Connect‟ status, data from host is transmitted to the other side Bluetooth device, and
any AT command is not accepted but this command, which is not echoed on the screen.
When Parani-
SD encounters a character „+‟ from host, it stops the data transmission and
waits for next 2 characters. If the next 2 characters aren‟t both „+‟, it restart to transmit data
including the first „+‟ as well. If not, it converts the operation status to „Standby‟.
If the data from host includes „+++‟, it will convert the operation status to „Standby‟. Notice
that Parani-SD holds data transmiss
ion when it encounters „+‟, until receiving next
character.
„+‟ is an escape sequence character by default, which is changeable by AT+SETESC.
A.3.14. AT+SETESC,nn
Response  OK
Purpose Change the escape sequence character
Description Escape sequence character set to „+‟ by default is changeable.
The parameter nn must be a printable character.