SENA Parani-SD1000U - Manual (Page 9)

2. Getting Started
This chapter describes how to set up the Parani-SD1000U.
Following items are required to get started:
- One PC with USB port.
- Terminal emulation program running on the PC.
2.1. Panel Layout
This section describes the panel layout of the Parani-SD1000U.
Figure 2-1 The panel layout of Parani-SD1000U
2.2. Connecting the Hardware
This section describes how to connect the Parani-SD1000U to the USB device.
2.2.1. Connecting Device to Parani-SD1000U
Connect the serial device to the Parani-SD1000U as shown below.