SENA Parani-SD1000U - Manual (Page 35)

Example AT+SETESC,42
A.3.15. ATO (ATOx, ATObdaddr)
Response None
Purpose Convert the operation status of „Standby‟ to „Connect‟
Description You can convert the operation status of „Standby‟ to „Connect‟ ready to transmit data. In
Node Switching mode, a specific slave can be specified to become an active connection by
specifying the connection number or the Bluetooth address.
Example ATO
ATO3
ATO000195000001
A.3.16. AT+BTCANCEL
Response  OK
Purpose Terminate the current task
Description This terminates a current executing task, such as Inquiry scan and Page scan, then
converts the operation status to „Standby‟
A.3.17. AT+BTSCAN
Response  OK
 CONNECT 112233445566
Purpose Wait for inquiry and connection from other Bluetooth devices
Description This allows the inquiry and connection from the other Bluetooth devices. The operation
status will be in „Pending‟ after this command. When connection is made and released, the
operation status is back to „Pending‟. To convert the operation status to „Standby‟
AT+BTCANCEL must be used.
This has the same effect as AT+BTSCAN, 3, 0.
When connection is made with other Bluetooth device, response will be „CONNECT‟ with
its BD address.
A.3.18. AT+BTSCAN,n,to
Response  OK
 CONNECT 112233445566
or
 OK
 ERROR
Purpose Wait for inquiry and connection from other Bluetooth devices for a given duration
Parameters n=1: Allows Inquiry scan
n=2: Allows Page scan
n=3: Allows both of Inquiry scan and Page scan
to= Time duration in seconds
Description For the given to, Parani-SD is waiting for the inquiry and connection from other Bluetooth
devices. If the parameter of to is 0, it will wait forever.
When connection is
made with other Bluetooth device, response will be „CONNECT‟ with
its BD address. If there is no connection made within this time duration, response is
„ERROR‟ and the operation status becomes to „Standby‟.