SENA Serial_IPTM Redirector 4.3 - Manual (Page 68)

Appendix A: Advanced Settings
A.3. Options
The Options tab of the Advanced Settings window
provides control of infrequently used settings. This tab is
present only in the redirector products, and only the
applicable settings appear in each product.
Delay COM Port Closure • All Redirectors
Products: All redirectors.
Default value: 8000 (8 seconds)
This setting changes the number of milliseconds that the
COM port will be considered open after an application
closes it. This feature minimizes the effect of a COM port being "handed off" between two processes.
For the DialOut and Serial/IP Redirectors, the connection to the modem or serial port on the server is not
disconnected until the specified amount of time has elapsed after the COM port is closed. Similarly, for the
COM/IP Redirector, any active network connections are not dropped until the delay occurs.
Update Routing Table Upon COM Port Open
Products: All redirectors except COM/IP.
Default setting: Enabled.
When enabled, the product adds a host route to the IP Address of the server (and to the IP Address of the
License Manager if a Site Edition) each time a COM port is opened. This action helps ensure that Dial-Up
Networking does not interfere with network connections of the redirector.
Enable Nagle Algorithm
A.3. Options