GE Industrial Solutions Entelliguard TU, MicroVersaTrip Plus and PM Conversion Kits - Manual (Page 7)

7
SECTION 4. INSTALLING THE CONVERSION KIT
This section describes the installation of the Entelliguard, MicroVersaTrip Plus and MicroVersaTrip PM and
conversion kit. The components provided with the kit are shown in Fig 3.
Figure 3. Components supplied with the conversion
kit
Trip Unit
Mounting Plate
Connector
Hardware
Current Sensor (for
800/1600)
Wiring Harness
Flux Shifter Support
Current Sensor
(for RL-2000)
Slotted Hole
Tapped Hole