GE Industrial Solutions HE300GEN251 - Manual (Page 43)

PAGE 44 23 SEP 1999 CH.8: INSTALLATION
GENTLY SEPARATE BOTTOM OF COVER FROM HEAT SINK
CASTING APPROX. ½ INCH TO CLEAR 2 MOUNTING
BOSSES & POWER BOARD.
SLIDE UP TO DISENGAGE
TABS SECURING UPPER END OF CASE. THEN RAISE
THE COVER UPWARD TO FREE THE TOP END.
WARNING: TO AVOID BREAKING TABS, DO NOT
SEPARATE THE BOTTOM MORE THAN ½ INCH.
REMOVE FOUR SCREWS
SECURING THE REGULATION
CARD TO STANDOFFS
AND REMOVE CARD.
REMOVE LOWER PLATE
REMOVE TWO SCREWS TO
BLOCKS
THREE TERMINAL
DISCONNECT
POWER CARD AND REGULATION CARD
DISCONNECT RIBBON CABLE BETWEEN
COVER TAB
Figure 8.2 – Installing GEN250