GE Industrial Solutions SG Series 225 & 300 Operating Manual - Manual (Page 38)

Modifications reserved Page 38/79
OPM_SGS_USM_M22_M30_2US_V010.doc User Manual SG Series 225 & 300 UL S2
` Home\Setup
SETUP
LEVEL 1 : USER
LEVEL 2 : SERVICE
V 
Setup screen
LEVEL 1 USER
Displays a sequence of screens with parameters which can
be user defined.
LEVEL 2 SERVICE
Only service is allowed.
At this level the parameters access is protected by a code.
` Home\Setup\User
DATE AND TIME
D M Y
Date : 15.05.2010
H M S
Time 15:37:25
V
Date and time screen
Date You can adjust the date of the real time clock
existing in the UPS by the means of this parameter.
The value you enter is thoroughly checked to be a
correct date in the format “DD.MM.YY”.
Hour You can adjust the time of the real time clock
existing in the UPS by means of this parameter.
The value you enter is thoroughly checked to be a
correct time in the format “HH.MM.SS”.
The time is specified in 24-hour format.
` Home\Setup\User
MODEM
Enabled : N
Init : BEQV1X3&D0S0=2
Alarm call : N
Delay : 30 sec
Tel 1 : 1
Tel 1 enabled : N
V
Modem screen 1
Enabled
You can enable/disable with Y/N the remote control
through modem calls by using this parameter.
For modem connection, the default setting is for serial port
J3 on Customer Interface.
Init
This parameter presents the modem initialization string.
It can be 40 characters long.
When editing this parameter the UPS considers that a blank character terminates the string.
If no blank character is found then all 40 characters are used.
Alarm call
This Y/N parameter controls the automatic events signaling through modem.
If this parameter is set to Y (Yes) the UPS itself will call the remote location when a new event occurs
Delay
This parameter controls the delay between the occurrence of a new event and the modem dialing.
It is useful because since the events typically do not occur isolated but in certain sequences, you can eliminate
the need for multiple dial-outs for such a sequence of events.
Tel 1
This parameter specifies a first telephone number to be used for modem dial-out.
The telephone number has a maximum 40 characters and cannot contain blanks.
If the desired number is shorter than 40 characters, the string will finish with blanks.
Tel 1 enabled
This parameter Y/N specifies if the first telephone number (Tel 1) will be used for dial-out.