2 part 2 — setting up the switch, 1 connect the console port, 2 connect to the computers or a lan – Asus GigaX2024X User Manual

Page 18: 3 attach the rps module, 4 attach the power adapter, Part 2 — setting up the switch, Connect the console port, Connect to the computers or a lan, Attach the rps module, Attach the power adapter

Advertising
background image

GigaX Series L2 Managed Switch User’s Guide

3.2

Part 2 — Setting up the switch

Connect the device to the power outlet, and your computer or network. See
Figure 4.

3.2.1

Connect the console port

For console management, use an RS232 (DB9) or a USB cable to connect
the switch. If you want to use WEB interface, connect your PC to the switch
using the Ethernet cable.

3.2.2

Connect to the computers or a LAN

You can use Ethernet cable to connect computers directly to the switch ports.
You can also connect hubs/switches to the switch ports by Ethernet cables.
You can use either the crossover or straight-through Ethernet cable to connect
computers, hubs, or switches.

Use a twisted-pair Category 5 Ethernet cable to connect the
1000BASE-T port. Otherwise, the link speed can not reach
1Gbps.

3.2.3

Attach the RPS module

Connect your RPS module to the RPS jack and make sure the other end of the
RPS is connected to the power cord. Connect to the power cord to a grounded
power outlet.

3.2.4

Attach the power adapter

1. Connect the AC power cord to the POWER receptacle on the back of

the switch and plug the other end of the power cord into a wall outlet or
a power strip.

2. Check the front LED indicators with the description in Table 4. If the

LEDs light up as described, the switch hardware is working properly.

18

Advertising