Asus GigaX2024X - Manual (Page 41)

GigaX Series L2 Managed Switch User Guide
Name: the group name.
Trunk ID: a number to identify the trunk group besides the group name.
LACP: Enable/Disable LCAP on selected trunk. LACP mode is fixed to be
Active.
Remove Trunk: Remove the selected trunk.
Port Icons: these port icons are listed in a way like the front panel. You
have to click on the icon the select the group members. The port can be
removed from the group by clicking the selected port again.
Click to make the setting send to the switch (HTTP server). Click
to refresh the settings to current value. To make the configuration
effective, go to “Save Configuration” page, then click .
You have to check the runtime link speed and duplex mode to make sure the
trunk is physically active. Go to Physical Interface and check the link mode in
the runtime status window for the trunk ports. If all the trunk members are in the
same speed and full duplex mode, then the trunk group is set up successfully.
If one of the members is not in the same speed or full duplex mode, the trunk is
not set correctly. Check the link partner and change the settings to have the
same speed and full duplex mode for all the members of your trunk group.
•
•
All the ports in the link aggregation group MUST operate
in full-duplex mode at the same speed.
•
All the ports in the link aggregation group MUST be
configured in auto-negotiation mode or full duplex mode.
This configuration will make the full duplex link possible. If
you set the ports in full duplex force mode, then the link
partner MUST have the same setting. Otherwise the link
aggregation could operate abnormally.
•
All the ports in the link aggregation group MUST have the
same VLAN setting.
•
All the ports in the link aggregation group are treated as a
single logical link. That is, if any member changes an
attribute, the others will change too. For example, a trunk
41