Asus Terminator A7VT - Manual (Page 94)

94 Chapter 5: BIOS information
Boot Up Floppy Seek [Enabled]
When [Enabled], the BIOS will seek the flopy disk drive to determine
whether the drive has 40 or 80 tracks. Configuration options: [Enabled]
[Disabled]
Boot Up Num-Lock Status [On]
Allows you to select the power-on state for the NumLock. Configuration
options: [On] [Off]
Typematic Rate Setting [Disabled]
Allows you to enable or disable the keyboard typematic rate setting. Set to
[Enabled] to configure the Type Rate and Type Delay items. Configuration
options: [Disabled] [Enabled]
The items Typematic Rate (Chars/Sec) and Typematic Delay become
configurable only when the item Typematic Setting is enabled.
Typematic Rate (Chars/Sec) [6]
Allows you to select the rate at which character repeats when you hold a
key. Configuration options: [6] [8] [10] [12] [15] [20] [24] [30]
Typematic Delay (Msec) [250]
Allows you to set the delay before key strokes begin to repeat.
Configuration options: [250] [500] [750] [1000]
OS Select for DRAM > 64MB [Non-OS2]
Select [OS2] only when you are using an OS2 operating system with
greater than 64MB RAM. Otherwise, set to [Non-OS2]. Configuration
options: [Non-OS2] [OS2]
Halt On [All Errors]
Sets the system to halt on errors according to the system functions
specified in each option. Configuration options: [All Errors] [No Errors] [All,
But Keyboard] [All , But Diskette] [All, But Disk/Key]