Asus Vintage User Manual
Page 29
ASUS Vintage-S800 barebone system
29
Follow these steps to install a PCI
or AGP card.
1.
Place the chassis on its side.
2.
Remove the metal bracket
opposite the slot that you wish
to use.
3.
Align the card golden fingers
to the slot and its metal
bracket to the slot opening on
the chassis.
4.
Press the card firmly until it is
properly seated on the slot.
5.
Secure the card to the chassis
with a bracket screw.
If your system came with the optional modem card, the PCI slot is
already occupied.
PCI slots (PCI1)
Metal bracket
AGP slot (AGP1)
2.7.2 Expansion card installation
2.7.3 Configuring an expansion card
After installing the expansion card, configure it by adjusting the software
settings.
1.
Turn on the system and change the necessary BIOS settings, if any.
See Chapter 5 for information on BIOS setup.
2.
Assign an IRQ to the card. Refer to the tables below.
3.
Install the software drivers for the expansion card.