Asus Vintage - Manual (Page 32)

32 Chapter 2: Basic Installation
5. Connect a power cable from
the power supply to the power
connector at the back of the
CD-ROM. Use the cable with
the white connector labeled
P1.
6. Connect one end of the IDE
ribbon cable to the IDE
interface at the back of the
CD-ROM, matching the red
stripe on the cable with Pin 1
on the IDE interface.
7. Connect one end of the
CD-ROM audio cable to the
4-pin connector at the back of
the CD-ROM.
8. Connect the other end of the
IDE ribbon cable to the
secondary IDE connector
(black connector labeled
SEC_IDE1) on the
motherboard.
Red stripe to pin 1
IDE ribbon cable
Power cable (P1)
CD-ROM audio cable
9. Connect the other end of the
audio cable to the black 4-pin
connector labeled CD1 on the
motherboard.
CD-ROM Connector
(CD1)
Secondary IDE connector
(SEC_IDE1)