Asus Vintage - Manual (Page 55)

ASUS Vintage-S800 barebone system 55
P4S800-MX PLED setting
PLED1
PLED+
1
NC
PLED-
AD1888
CODEC
13. Power LED Lead (3-1 pin PLED1)
This 3-1 pin connector is for the system power LED. Connect the
3-pin power LED cable from the system chassis to this connector.
The LED lights up when you turn on the system power, and blinks
when the system is in sleep mode.
The power LED lead (PLED1) is present only on PCB versions 1.03 or
later.
14. System panel connector (10-1 pin F_PANEL1)
This connector supports several chassis-mounted functions.
P4S800-MX System panel connector
F_PANEL1
PLED- PWR PLED+
Ground
GND
Reset
IDE_LED+ IDE_LED-
PLED
RESET
PWRBTN*
HDLED
* Requires an ATX power supply.
AD1888
CODEC
• System power LED (3-pin PLED)
This 3-pin connector is for the system power LED. Connect the
chassis power LED cable to this connector. The system power LED
lights up when you turn on the system power, and blinks when the
system is in sleep mode.