Asus Vintage - Manual (Page 49)

ASUS Vintage-S800 barebone system 49
2. Floppy disk drive connector (34-1 pin FLOPPY1)
This connector is for the provided floppy disk drive (FDD) signal
cable. Insert one end of the cable to this connector, then connect the
other end to the signal connector at the back of the floppy disk drive.
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
P4S800-MX Floppy disk drive connector
PIN 1
FLOPPY1
AD1888
CODEC
Pin 5 on the connector is removed to prevent incorrect cable connection
when using a FDD cable with a covered Pin 5.
3. Front panel audio connectors (10-1 pin FP_AUDIO1)
This connector is for a chassis-mounted front panel audio I/O module.
Connect one end of the audio I/O module cable to this connector for
analog audio input/output.
P4S800-MX Front panel audio connector
FP_AUDIO1
BLINE_OUT_L
MIC2
Line out_R Line out_L
BLINE_OUT_R
NC
MICPWR
+5V
A
AGND
AD1888
CODEC