Asus Terminator Tualatin - Manual (Page 23)

ASUS Terminator Barebone System 23
2.5 Install a Hard Disk Drive
6. Connect one end of the IDE
hard disk ribbon cable to the
IDE interface at the back of the
HDD, matching the red stripe
on the cable with Pin 1 on the
IDE interface.
Red Stripe to Pin 1
IDE Ribbon Cable
7. Connect the other end of the
IDE ribbon cable to the
primary IDE connector (blue
connector labeled IDE1) on
the motherboard.
Power Cable
(HDD)
Primary IDE Connector
(IDE1)
5. Connect a power cable from
the power supply to the power
connector at the back of the
HDD. Use the cable with the
white connector labeled HDD.