Asus Terminator Tualatin - Manual (Page 93)

ASUS Terminator Barebone System 93
Onboard FDC Swap A & B [No Swap]
This field allows you to reverse the hardware drive letter assignments
of your floppy disk drives. Configuration options: [No Swap] [Swap
AB]
Onboard FDC Smart FIFO [Disabled]
Configuration options: [Enabled] [Disabled]
Onboard Serial Port 1 [3F8H/IRQ4]
Onboard Serial Port 2 [2F8H/IRQ3]
These fields allow you to set the addresses for the onboard serial
connectors. Serial Port 1 and Serial Port 2 must have different
addresses. Configuration options: [3F8H/IRQ4] [2F8H/IRQ3] [3E8H/
IRQ4] [2E8H/IRQ10] [Disabled]
UART2 Use Standard Infrared [Disabled]
When enabled, this field activates the onboard standard infrared
feature and sets the second serial UART to support the infrared
module connector on the motherboard. If your system already has a
second serial port connected to the onboard COM2 connector, it will
no longer work if you enable the infrared feature. Configuration
options: [Disabled] [Enabled]
Onboard Parallel Port [378H/IRQ7]
This field sets the address of the onboard parallel port connector. If
you disable this feature, Parallel Port Mode and ECP DMA Select
configurations will not be available. Configuration options: [Disabled]
[378H/IRQ7] [278H/IRQ5]
Parallel Port Mode [ECP+EPP]
This field allows you to set the operation mode of the parallel port.
[Normal] allows normal-speed operation but in one direction only;
[EPP] allows bidirectional parallel port operation; [ECP] allows the
parallel port to operate in bidirectional DMA mode; [ECP+EPP] allows
normal speed operation in a two-way mode. Configuration options:
[Normal] [EPP] [ECP] [ECP+EPP]
ECP DMA Select [3]
This field allows you to configure the parallel port DMA channel for
the selected ECP mode. This selection is available only if you select
[ECP] or [ECP+EPP] in Parallel Port Mode above. Configuration
options: [1] [3]