Xylem ProLab 4000 - Manual (Page 101)

ProLab 4000 Ion concentration
101 ba75646e03 12/2012
9.2.3 Measurement settings
All settings for ion selective measurements are done in the Measuring
menu.
Menu item Setting Description
Measuring
– ISE settings
– Units – mg/l
– mol/l
– mg/kg
– ppm
– % Selection with which unit the mea-
surement result and calibration
standards should be displayed.
– Ion type Ag, Br, Ca, Cd, Cl, CN, CO2, Cu,
F, I, K, Na, NH3, NH4, NO3, Pb,
S, ION Selection of the ion type to be
measured
With the ION setting it is possible
to measure ions that are not men-
tioned in the list. Depending on
the selected unit, (see ISE set-
tings/Units) a further entry may be
necessary (molar mass of the ion
or density of the solution).
– Blank value correction
– Reference measure-
ment
– Input reference
value...
– Burettes settings... Activate burettes () Activating/deactivating the
burette control
INFO: If the burette control is
active, data output to the RS232
interface (printer) is deactivated.