Extron Electronics Dante Controller - Manual (Page 23)

Dante Controller User Guide
Copyright © 2013 Audinate Pty Ltd. All rights reserved. -23-
Using Dante Controller
Dante Controller presents the user with two main types of view: Network View and Device View.
Important: After making changes to Dante network routing (e.g. subscriptions, device names,
channel labels etc.) please wait at least 5 seconds before disconnecting or powering down any
affected devices. This ensures that the new information has been properly saved to the devices.
Device configuration (e.g. sample rates, latency, clock settings) are saved instantly.
Note: Mac OSX users: Please note that the key combinations shown below are for Windows users.
When using Dante Controller on a Mac, please use the “Command (CMD)” or “Apple” key instead of
the “Control” key when following the instructions below, and substitute standard Mac key
combinations where applicable – see the Dante Controller menu for details.
Network View
When Dante Controller is started it always begins by presenting the Network View: