Extron Electronics Dante Controller - Manual (Page 40)

Dante Controller User Guide
Copyright © 2013 Audinate Pty Ltd. All rights reserved. -40-
Indicates that the link is operating at 100Mbps
Indicates that the link is not connected or that there is an error.
The IP address will read N/A, and Tx and Rx utilization will be 0
kbps.
Secondary Interface
This provides the same information for the secondary interface that is provided for the primary interface, as
described above.
Note: The secondary network interface will only be displayed if the device supports redundancy.
Device Config Tab
This tab on the device view window allows the user to configure device specific parameters. The specific
options available will depend on the capabilities of the device. In the case where a device does not support
configuration via Dante Controller, the tab will be disabled.
Note: Dante Virtual Soundcard does not have a Config Tab available on Dante Controller. The Dante
Virtual Soundcard User Interface on the PC or Mac must be used to configure these devices.