Extron Electronics Dante Controller - Manual (Page 34)

Dante Controller User Guide
Copyright © 2013 Audinate Pty Ltd. All rights reserved. -34-
Device View Menu bar
The menu bar in the Device View contains three menus: File, Device and Help.
File
n
Load Preset: loads a configuration from a file
n
Save Preset: saves configuration for currently displayed devices to a file
n
Exit: Exits Dante Controller
The use of Presets is described in detail later in this guide.
Device
n
Refresh: Refreshes the displayed network / device data
n
Device View: Opens a new Device View window
Help
n
About: Shows Dante Controller version and current log file
n
License: Displays the license text
n
Contents: Opens a help window and displays help contents
Device View Toolbar
The Device View toolbar contains 4 buttons: Refresh, Web Configure, Identify, and Multicast
Configuration. These provide the following functionality:
Refresh Re-load routing and configuration information for
the current device
Web Config Some Dante devices can be configured via a web
interface. This button opens a web browser window
which can be used to perform functions such as
firmware upgrades. This feature is not supported on
all Dante devices.
Identify Identify the current device by, for example, causing
its LEDs to flash. Note that this feature is not
supported on all Dante devices.
Multicast Configure multicast transmit flows on the current
device.
The toolbar also provides a drop down list of all available devices on the network which allows the user to
switch to a different device.
Device View Tabs
Below the toolbar, the Device View window has five tabs: Receive, Transmit, Status, Device Config and
Network Config, which are described in detail below.