Extron Electronics MLC 206 AAP EC User Guide - Manual (Page 24)

Installation, cont’d
MediaLink Controllers • Installation 2-16
Mounting the MLC to a wall or furniture
1. Attach the optional lectern mounting faceplate to the MLC with machine
screws, as described on page 2-4 in “Replacing faceplates and labels” in this
chapter.
2. With power disconnected at the source, insert the MLC into the wall or
furniture.
3. Fasten the MLC and faceplate directly to the furniture or wall using wood
screws.
If the MLC (and any accessories such as control modules or an IR Link) is not
mounted to a grounded metal wall box,
• Ground each faceplate directly to an earth ground. Or...
•
Tie each faceplate to it’s circuit board and power supply via a ground pin on
one of the connectors.
Do not tie a product’s faceplate to both a separate earth ground and the circuit
ground (via a connector pin). If you tie a product to two different ground
sources, you may introduce ground loops or other grounding-related problems
into the system.
Rack mounting the MLC
1. Attach the optional rack mounting faceplate to the MLC with machine screws,
as described on page 2-4 in “Replacing faceplates and labels” in this chapter.
2. With power disconnected at the source, fasten the MLC and faceplate to the
rack using the supplied machine screws as shown in the following
illustration.
MediaLink
DISPLAY POWER
VOLUME
MA X/
MIN
VCR
DVD
Laptop
Rack mounting the MLC