Extron Electronics MLC 206 AAP EC User Guide - Manual (Page 59)

4-27 MediaLink Controllers • Serial Communication
4. Enter a filename of your choice for storing the configuration settings, then
select Save.
The Emulation Configuration dialog box appears, as shown below.
5. Select the MediaLink equipment that will be part of the system you want to
configure, then click on OK. The Extron MediaLink Control Program
windows appear.
6. Select the desired settings in each section of the program.
In emulation mode you cannot perform IR learning. You must have an MLC
connected to the host computer for IR learning.
7. To save the configuration for future use, follow steps 1 and 2 in “Saving and
restoring configurations” on page 4-23.