Extron Electronics System 5 IP Series Setup Guide - Manual (Page 25)

System 5 IP Switchers • Software Setup
System 5 IP Software Setup, cont’d
3-20 System 5 IP Switchers • Software Setup 3-21
3 . Enter a name (Shutdown) in the Enter Scheduled Action
Name field.
4 . Indicate the time for the desired action and uncheck
inactive times (weekend hours when staff are away, for
example).
For events that occur at the same time daily, change the
time alongside the Set All button. Click the Set All button
to automatically change all the days of the week.
5 . Click Next. This takes you to the actions page, where you
can specify the action.
Display shutdown action selection dialog
6 . Select the device to be scheduled (for our purposes,
choose the Epson PowerLite 7700p) from the Subject Port
window.
7 . Select the action Power Control-Off from the Available
Options window, then click the Apply Action button.
8 . Click Done. The dialog box closes.
Step 9: Create a Dsplay Lamp Hour Warnng
E-mal
Global Configurator’s monitoring feature enables you to
configure a System 5 IP switcher to monitor many parameters
of the connected display devices. For example, a monitor alert
can warn the school administrator if a display lamp hour limit
is close to expiration or if a display is inexplicably disconnected
from the System 5 IP switcher.
To set a display lamp hour warning e-mail, do the following:
1
. Click the Monitor tab in the Global Configurator window.
2 . Click the Add Monitor button below the Monitored
Conditions dialog. The Monitored Conditions Wizard
dialog box appears.
3 . Enter a name (Lamp hour) in the Enter Monitored
Condition Name field area. The label now appears in the
left pane.
4 . Click the Next button. This takes you to the actions page,
where you can specify the action.
Monitored Conditions Wizard dialog
5 . In the Subject Port window, select the display
(choose Epson PowerLite 7700p) for which the lamp hour
warning is to be set. A list of monitoring options appears
under the Available Options window.