Extron Electronics System 5 IP Series Setup Guide - Manual (Page 4)

 System 5 IP Switchers • Table of Contents
Table of Contents
Chapter One • Introducton .................................................... 1-1
About this Manual ..................................................................... 1-2
About the System 5 IP Series Switchers ............................. 1-2
About Global Configurator ..................................................... 1-3
System Requirements ................................................................ 1-4
Installing the Software ............................................................. 1-4
Updating Firmware .................................................................... 1-5
Chapter Two • System 5 IP Hardware Setup ................ 2-1
Rear Panels and Cabling ........................................................... 2-2
A/V input and video output connections.............................. 2-2
Audio output connections...................................................... 2-3
Control connections................................................................ 2-5
Front Panel Features and Basic Operation ....................... 2-10
Control ports......................................................................... 2-11
Buttons .................................................................................. 2-11
Indicators............................................................................... 2-13
Chapter Three • System 5 IP Software Setup ............. 3-1
Online Training ............................................................................ 3-3
Step 1: Download Device Drivers ........................................ 3-3
Step 2: Create a New Project ................................................ 3-4
Step 3: Add a System 5 IP Switcher and Define its
Location
......................................................................................... 3-6
Step 4: Define E-mail Settings ............................................. 3-8
Defining e-mail server settings .............................................. 3-8
Setting up e-mail notifications .............................................. 3-9
Adding e-mail contacts ......................................................... 3-11
Step 5: Add a Serial and an IR Device ............................... 3-12
Downloading additional drivers .......................................... 3-12
Adding a serial driver .......................................................... 3-12
Adding an IR driver ............................................................... 3-13
Step 6: Configure the Front Panel Buttons ..................... 3-14
Configuring an input button ................................................ 3-15
Configuring the On and Off buttons ................................... 3-16
Step 7: Configure the Control Modules Using the
Auto Fill Feature
........................................................................ 3-17