IPX DDK-1700 - Manual (Page 14)

3.2 Network Settings Configuration
3.2.1 Enabling DHCP Function
The DDK-1700’s default setting is DHCP OFF. Users can build the camera’s working environment
with a static IP address. The default static IP is 192.168.1.168.
3.2.2 Setting an IP Address
You need to set an IP address for the unit if DHCP is not supported on the network. Otherwise,
please follow the instructions given below:
Note:
The default static IP is 192.168.1.168.
Set the IP, MASK and GATEWAY settings to the following:.
IP:
192.168.1.X
MASK: 255.255.255.0
GATEWAY:
0.0.0.0
NOTE:
When a DDK-1700 is connected to a WAN, you must acquire a unique, permanent IP
address and correctly configure the MASK and GATEWAY settings according to
your network architecture. If you have any questions regarding those settings,
please consult a qualified MIS professional or your ISP.
NOTE: When connecting to a network, each connected DDK-1700 must be assigned a
unique IP address which must be in the same class type as your network address.
IP addresses are written as four sets of numbers separated by periods; for example,
192.168.1.1 Therefore, if the connected network is identified as Class C, for example,
the first three sets of numbers of the DDK-1700 IP address must be the same as the
network address. If the connected network is identified as Class B, the first two sets
of numbers of the DDK-1700 IP address must be the same as the network address. If
you have any questions regarding these settings, please consult a qualified MIS
professional or your ISP.
14