IPX DDK-1700 - Manual (Page 68)

when an event is triggered.
5. Click “Submit” to save or click on “Don’t Submit” to go back to the Event main page.
Event settings:
(1) Click
Add
in the Event area on Event Settings page to open the Event settings page. On
this page, you can configure three settings: Trigger, Event Schedule, and Action to set an
event. A total of 3 different event settings can be configured.
(2) Enter the Event Name for the event setting.
(3) Select “Enable this event” option to enable the event setting.
(4) Set the event priority from: “normal”, “high” and “highest”. Events with a higher priority will
be executed first.
(5) Enter the duration in seconds to restart motion detection after a motion is detected
(6) An event is the action initiated by the user-defined trigger source. Set the event details for
each as follows.
Trigger:
This option defines when to trigger the DDK-1700. The trigger source can
be configured to use the DDK-1700’s built-in motion detection , periodic, external
digital input devices, or system boot:
(a) Video motion detection: This option makes use of the built-in motion
detection mechanism as a trigger source. To enable this function, you need
to first configure a motion detection window.
(b) Periodic: This option allows the DDK-1700 to trigger periodically as defined
in minute intervals up to 99999 minutes.
(c) Digital input: This option allows the DDK-1700 to use an external digital
input device or sensor as a trigger source.
(d) System boot: This option triggers the DDK-1700 when the power to the
DDK-1700 is disconnected.
(e) Network Loss: This option triggers the DDK-1700 when the network to the
DDK-1700 is disconnected.
68