NXG Technology NX-RM505 User Manual
Page 16
4. Programming the NX-RM505 to Control
Your Components
12.
When you are finished programming your remote, exit from the
preprogramming mode by pressing the MAIN button and then exit
from the SETUP mode by pressing the MAIN button once again.
Tip: You can change the pre-programmed code for each device at any time
by following the steps above. The new code will override the old code. For
example, this would be gone if you replaced your old TV with a new one.
2. Auto Scan With Three-Digit Number
You can also program your remote control by sending out a series
of Power Off commands for different brands stored in the library by
using the following steps. This is similar to the first method, except
it is easier to move through all of the device codes for your device
and make note of each one that turns your device OFF.
1.
Manually turn on the device you plan to operate.
2
. Go to the SETUP mode by pressing both the MAIN and ENT
buttons simultaneously for three seconds.
3.
Press the P-PRO button next to the LCD screen.
NX-RM505
16
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 16