NXG Technology NX-RM505 - Manual (Page 22)

4. Programming the NX-RM505 to Control Your
Components
2. Programming The Ten Device Buttons
This will program ONE learned code onto the device button, so that
when you select that Device, it will send out the learned signal as it
changes to that Device's function pages.
1 Go to the SETUP mode by pressing both the MAIN an ENT buttons
simultaneously for three seconds.
2 Press the LEARN button next to the LCD screen.
3 Important: Press the PAGE button.
4 Place your original remote control head to head with the NX-RM505
about 2 inches apart on a flat surface.
5 Select any of the ten device buttons you wish to program on the NX-
RM505. Press the button on your original remote control you wish to
program into the device button you have chosen on the NX-RM505.
Once the NX-RM505 has received the signal, the NX-RM505 will
flash ‘Good’ on the LCD screen, indicating it learned the code
correctly. If it flashes ‘Fail’, repeat from Step 4 until it learns
successfully. (Please enter the code signal within 20 seconds of
programming.)
6 Return to Step #5 until you have programmed all of the device
buttons that you require.
NX-RM505
22
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 22