NXG Technology NX-RM505 - Manual (Page 44)

12. Cloning NX-RM505
7 Press the START button on both units to begin cloning. It will
take about 40 seconds to complete the cloning and it will flash
‘GOOD’ upon completion of the cloning.
8 Exit from the Cloning mode by pressing the MAIN button and
then exit from the SETUP mode by pressing the MAIN button
once again.
13. Adjustment of LCD Contrast
Pressing the MAIN button and Up on the joystick simultaneously
will make the LCD contrast darker and pressing the MAIN button
and Down on the joystick simultaneously will make the LCD
contrast brighter.
NX-RM505
44
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 44