NXG Technology NX-RM505 - Manual (Page 17)

4. Programming the NX-RM505 to Control
Your Components
4 The remote will be flashing ‘SELECT BUTTON’. Press the device you
wish to program. (For example, to program TV, press the TV button.)
5 The remote will be flashing ‘FROM TABLE’. Select the device from
which the scanned code will be selected.
(Important: If you have already relabeled your device keys, your LCD
screen will not look like the illustration above. Select the appropriate
LCD button for the ‘FROM TABLE’ using the labels as shown in the
illustration on page 11 of this manual. For example, if you have
relabeled AUX as LIGHTS, you would still push the bottom-left
button to access the AUX Code Table.
6 Point the remote control toward the component and alternately press
the UP (or DOWN) button on the LCD and the Power button. If the
right code number is sent, the component will turn off right after the
code number is transmitted.
(Please press the UP (or DOWN) button within 20 seconds of
beginning programming, otherwise the remote will revert to the
SETUP menu and then after a period of time, it will go back to the
MAIN device page.)
NX-RM505
17
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 17