AUMA Electric part-turn actuators SG 05.1 - 12.1_SGR 05.1 - 12.1 NORM - Manual (Page 7)

4. Transport, storage and packaging
4.1 Transport
.
For transport to place of installation, use sturdy packaging.
.
Do not attach ropes or hooks to the handwheel for the purpose of lifting by
hoist.
.
If part-turn actuator is mounted on valve, attach ropes or hooks for the
purpose of lifting by hoist to valve and not to part-turn actuator.
Fitting the ball handle:
To avoid damage during transport, the ball handles are fitted to the inside of the
handwheel. Prior to commissioning, the ball handle has to be fitted in the
correct position.
.
Remove cap nut (figure A).
.
Pull out ball handle and re-insert in correct position.
.
Fasten with cap nut.
.
Remove label from the handwheel for fitting the ball handle.
4.2 Storage
.
Store in well-ventilated, dry room.
.
Protect against floor dampness by storage on a shelf or on
a wooden pallet.
.
Cover to protect against dust and dirt.
.
Apply suitable corrosion protection agent to uncoated surfaces.
If part-turn actuators are to be stored for a long time (more than 6 months), the
following points must be observed additionally:
.
Prior to storage: Protect uncoated surfaces, in particular the output drive parts
and mounting surface, with long-term corrosion protection agent.
.
Check for corrosion approximately every 6 months. If first signs of corrosion
show, apply new corrosion protection.
After mounting, connect part-turn actuator immediately to elec-
trical mains, so that condensation is prevented by the heater.
4.3 Packaging Our products are protected by special packaging for the transport ex works. The
packaging consists of environmentally friendly materials which can easily be
separated and recycled.
We use the following packaging materials: wood, cardboard, paper, and Poly-
urethane foam. For the disposal of the packaging material, we recommend recy-
cling and collection centers.
7
Part-turn actuators SG 05.1 – SG 12.1 / SGR 05.1 – SGR 12.1
Operation instructions AUMA NORM
Figure A
Cap nut
Ball handle
Ball handle