MoTeC M1 Tune User Manual - Manual (Page 39)

User Manual
WORKSHEET COMPONENTS
Printed documents are not controlled Page 38
10.8 TABLE TARGET COMPONENT
The Table Target component is commonly used when tuning an engine. The whole component
box represents the currently selected table. The floating red square shows where the live
channel values sit, compared to the currently selected table site.
Example Table Target
The most common use of the Table Target is when tuning an engine on the dyno. The tuner
would select the site that they would like to tune. The engine would then be adjusted in throttle
or load so as to position the square in the middle of the Table Target component box. When the
square is in the middle of the target, the engine live value is the same as the selected site value.
Once the engine live value and the site match, any changes made to that site value will
correspondingly by made to the running engine live value.
10.9 CHANNEL LIST COMPONENT
The Channel List component displays a filtered and sorted list of channels, and their live values.
Example Channel List