MoTeC ESDL3 - Manual (Page 10)

6 Installation
Installation
This section provides information on how to install the Dash Logger in the
vehicle and connect it to other devices. It will also provide information on how
to install the software.
Mounting and Wiring
The Dash Logger has three threaded mounting posts. For further details see
Mounting Dimensions
Mounting Tips
• Avoid twisting the case: use washers between the unit and the mounting
panel to ensure that the unit is mounted only at the mounting points and
do not over tighten the mounting screws.
• Vibration isolation may be desirable if the vehicle vibrates severely.
• Mount so that the connector may be easily accessed.
• Orientation: for best contrast, the display should be viewed at an angle of
approximately 20 degrees, However the Dash Logger will give good
contrast between 0 and 40 degrees. Display reflections should also be
considered when determining the mounting angle.
The SDL3 uses a 37 pin Autosport connector. See Connector and SDL3 Pin
List By Function for full details.
Wiring Tips
• To ensure that the connector is sealed, plug unused holes with filler plugs.
A heat shrink boot may also be used if desired.
• Use 22# Tefzel wire (Mil Spec M22759/16-22) (5 A max at 100 C)
• Tefzel wire is difficult to strip unless the correct stripping tool is used.
• Be careful not to nick the wires as this may result in wire failure or poor
crimping.