MoTeC ESDL3 - Manual (Page 9)

MoTeC Introduction 5
small Video Sync Module (VSM) to be connected to an auxiliary output of the
Dash Logger and to the audio input of the camera.
Lambda Measurement
PLM
The PLM Professional Lambda Meter measures the air fuel ratio over a
wide range of mixtures with fast response time. It is compatible with Bosch
LSU and NTK UEGO Lambda sensors and displays the Lambda readings
via the integrated display.
LTC/LTCD
The LTC Lambda to CAN (Dual) meters provide accurate Lambda
measurements even when the exhaust gas temperature changes rapidly.
They are compatible with the Bosch LSU 4.9 Lambda sensor and transmit
Lambda readings via the CAN bus.
Remote Displays
A remote display device may be connected to the Dash Logger to allow
display of any value that the Dash Logger calculates, such as lap times and
warning alarm messages.
The Dash Logger supports MDD displays which are connected via CAN.
PDMs
Power Distribution Modules are designed to replace conventional relays,
fuses and circuit breakers by providing electronically switched power to the
various electrical systems in the vehicle. This simplifies wiring and switch
requirements, while increasing reliability.
Full diagnostic information, including output currents and error status can be
transmitted via CAN to the Dash Logger.
Several models are available to suit vehicles with different complexity ranging
from 15 to 32 outputs and 12 to 23 inputs.
Other Devices
Many other devices can be connected to the Dash Logger.