ALESIS 03D - Manual (Page 143)

Effects Parameters
133
03D—Owner’s Manual
DUAL PITCH
REV+CHORUS
Parameter Range Description
PITCH 1 –24 to +24 Amount of pitch change 1 (semitones).
FINE 1 –50 to +50 cent Fine adjustment (1 cent steps) for pitch change 1.
PAN 1 L16–CENTER–R16 Pan for pitch change 1.
MODE 0–10
Precision of the pitch change. Higher settings will produce
more accuracy, but longer delay time.
DLY 1 0.1–1000.0 ms Delay time of pitch change 1.
FB.G 1 –99 to +99% Feedback amount for pitch change 1.
OUT 1 –100 to +100 Level of pitch change 1.
PITCH 2 –24 to +24 Amount of pitch change 2 (semitones).
FINE 2 –50 to +50 cent Fine adjustment (1 cent steps) for pitch change 2.
PAN 2 L16–CENTER–R16 Pan for pitch change 2.
DLY 2 0.1–1000.0 ms Delay time of pitch change 2.
FB.G 2 –99 to +99% Feedback amount for pitch change 2.
OUT 2 –100 to +100 Level of pitch change 2.
Parameter Range Description
REV.TIME 0.3–99.0 s Length of reverb.
INI.DLY 0.1–500.0 ms
Delay time until the early reflections of the reverb are
heard.
HI.RATIO 0.1–1.0
Length of the high frequency portion of the reverb,
expressed as a ratio relative to REV.TIME.
DIFF. 0–10 Left/right spread of the reverb sound.
DENSITY 0–100% Density of the reverb.
HPF
THRU,21 Hz–8.0
kHz
Cutoff frequency of the high pass filter.
LPF
50 Hz–16.0 kHz,
THRU
Cutoff frequency of the low pass filter.
REV.BAL 0–100%
Balance of reverb and chorus. 0 is only chorus, 100 is only
reverb.
FREQ. 0.05–40.00 Hz Modulation speed.
PM DEPTH 0–100% Pitch modulation depth.
AM DEPTH 0–100% Volume modulation depth.
MOD.DLY 0.0–500.0 ms
Delay time from the direct sound until the modulated
sound.
WAVE SINE, TRI Modulation waveform. SINE: sine wave, TRI: triangle wave