ALESIS 03D User Manual
Page 265
Display Messages
255
03D—Owner’s Manual
TC TYPE MISMATCH!
Timecode that is different from the automix Time Base set-
ting has been input. The automix may not play back cor-
rectly. Review and correct the setting.
TO HOST: DATA FRAMING ERROR!
An incorrect signal may have been input to the TO HOST
connector.
TO HOST: DATA OVERRUN!
An incorrect signal may have been input to the TO HOST
connector.
TO HOST: DATA PARITY ERROR!
An incorrect signal may have been input to the TO HOST
connector.
TO HOST: RX BUFFER FULL!
The 03D is probably receiving too much MIDI data at the
TO HOST connector.
TO HOST: TX BUFFER FULL!
The 03D is probably transmitting too much MIDI data
from the TO HOST connector.
WRONG WORD CLOCK!
The received wordclock is not correct and the 03D cannot
synchronize correctly. Select an appropriate wordclock by
reviewing the system connections, or use the AUTO NAVI-
GATE function on the D.in Setup page of the DIO func-
tion.
YGDAI INPUT SYNC ERROR!
The digital audio signal connected via the YGDAI card is
not synchronized with the wordclock master. This may
cause noise. Make sure that the device feeding the YGDAI
card inputs is synchronized to the master wordclock. Even
if the sync system is correctly configured, the wordclock
may become unstable until the digital MTR enters chase
mode, and this message may appear. This message can be
disabled by setting the YGDAI IN SYNC CAUTION prefer-
ence to OFF on the Prefer. page of the UTILITY function.
Message
Meaning